Improvement of maintenance of machines for forestry works during the diagnostics of technical state of operating materials
DOI:
https://doi.org/10.31548/machenergy2020.01.147Keywords:
machine for forestry work, the internal combustion engine, motor oil, diagnostics, technical maintenance.Abstract
To support machines for forestry work in a healthy state it is necessary to conduct routine maintenance, the frequency set by the manufacturer. Manufacturer's recommended frequency, which is measured in kilometers or hours of operation, corresponds to the average operating conditions of machines for forestry work. In real conditions of operation of machines for forestry work may be accompanied by more heavy loads, prolonged idle, work in difficult conditions. Given the age of machines for forestry work and such conditions, should meet more frequently. On the contrary, when you work in milder conditions, it may be possible to increase the interval between. While regulatory and technical documentation provided to increase the frequency and wide use of means of diagnosing the technical condition of machines for forestry work, the results of which are projected technical condition of mobile power means (MPM) and its residual life. One of the most loaded parts of machines for forestry work is the internal combustion engine (ICE). An operating condition of the internal combustion engine depends on many factors and one of which is an operating condition of the lubrication system of the internal combustion engine, As a rule, one of the main factors influencing the frequency of service not only, but also a machine for forestry work in General is changing the lubricant in internal combustion engines. Lubricant in the engine stands engine oil. Thus, an operating condition of the internal combustion engine is impossible without timely replacement of engine oil, which is a time-consuming and expensive work at ICE machinery for forestry work.
References
Shevchuk, R. S., Krupych, R. (2015). Manual vibro-impact fruit shake. MOTROL. Commission of motorization and energetics in agriculture. Lublin-Rzeszow. Vol. 17. №4. 153-159.
Semen, Y. V., Krupych, O. M., Shevchuk, R. S. (2006). Energy efficiency of the use of pneumohydraulic accumulators in hydraulic drives for fruit-harvesting machines. MOTROL. Motoryzacja i Energetyka Rolnictwa. Lublin: Akademia Rolnicza, T. 8A. 251-257.
Cherevko, G., Krupych, O., Krupych, R. (2013). Development of the system for the formation of the material and technical base of agriculture in Ukraine. MOTROL. Commission of motorization and energetics in agriculture. Lublin-Rzeszow, Vol. 5, №4. 97-106.
Sydorchuk, O., Triguba, A., Makarchuk, O. (2012). Optimization of the life cycle of integrated programs for harvesting grain crops. MOTROL. Commission of motorization and energetics in agriculture. Lublin, Vol. 14, №4. 131-140.
Sydorchuk, O., Ivasjuk, I., Syatkovskyy, A. (2012). Influence subject to conditions terms of tillage, planting summer-autumn period. MOTROL. Commission of motorization and energetics in agriculture. Lublin, Vol. 14, №4. 16-20.
Sydorchuk, O., Ivasiuk, I., Ukraynecz, V. (2013). Harmonization of the components of the technological system of soil cultivation and sowing of winter crops. MOTROL. Commission of motorization and energetics in agriculture. Lublin-Rzeszow, Vol. 15, №4. 180-186.
Sydorchuk, O., Sydorchuk, L., Demidyuk, N., Sivakovskaya, E. (2014). Method of creating a conceptual model of management - information systems of field crop cultivation. MOTROL. Commission of motorization and energetics in agriculture. Lublin-Rzeszow, Vol. 16, №4. 26-31.
Rogovskii Ivan. (2014). Methodology of development of normative documents ensure the efficiency of agricultural machines. MOTROL. Motorization and power industry in agriculture. Lublin. Vol. 16. №2. 253-264.
Rogovskii Ivan. (2016). Graph-modeling when the response and recovery of agricultural machinery. MOTROL. Motorization and power industry in agriculture. Lublin. Vol. 18. №3. 155-164.
Rogovskii, I. L., Melnyk, V. I. (2016). Model of parametric synthesis rehabilitation agricultural machines. Scientific Herald of National University of Life and Environmental Science of Ukraine. Series: Technique and energy of APK. Kyiv. No 241. 387-395.
Titova, L. L., Rogovskii, I. L. (2017). Technology recovery of power device of machines for forestry work. Scientific Herald of National University of Life and Environmental Science of Ukraine. Series: Technique and energy of APK. Kyiv. No 258. 369-380.
Rogovskii, I. L. (2016). Analysis of model of recovery of agricultural machines and interpretation of results of numerical experiment. Scientific Herald of National University of Life and Environmental Science of Ukraine. Series: Technique and energy of APK. Kyiv. No 254. 424-431.
Rogovskii, I. L. (2017). Probability of preventing loss of efficiency of agricultural machinery during exploitation. Scientific Herald of National University of Life and Environmental Science of Ukraine. Series: Technique and energy of APK. Kyiv. No 258. 399-407.
Rogovskii, I. L. (2017). Conceptual framework of management system of failures of agricultural machinery. Scientific Herald of National University of Life and Environmental Science of Ukraine. Series: Technique and energy of APK. Kyiv. No 262. 403-411.
Lyudmila Titova, Ivan Rogovskii. (2014). The effectiveness of technical exploitation of the forest MES. MOTROL. Motorization and power industry in agriculture. Vol. 16, № 3. 313-321.
Lyudmila Titova, Ivan Rogovskii. (2015). Improving the recovery efficiency of machines for forestry work. MOTROL. Motorization and Energetics in Agriculture. Vol. 17, № 3. 298-310.
https://doi.org/10.1505/146554815815982657
Lyudmila Titova, Ivan Rogovskii. (2017). System of control of parameters technical condition of machines for forestry work. TEKA. An International Quarterly Journal on Motorization, Vehicle Operation, Energy Efficiency and Mechanical Engineering. Lublin-Rzeszów. Vol. 17. No 3. 73-82.
Rogovskii Ivan, Titova Liudmyla, Novitskii Andriy, Rebenko Victor. (2019). Research of vibroacoustic diagnostics of fuel system of engines of combine harvesters. Proceedings of 18th International Scientific Conference "Engineering for rural development". Jelgava, Latvia, May 22-25, Latvia University of Agriculture. Faculty of Engineering. Vol. 18, pp. 291-298.
Downloads
Published
Issue
Section
License
Relationship between right holders and users shall be governed by the terms of the license Creative Commons Attribution – non-commercial – Distribution On Same Conditions 4.0 international (CC BY-NC-SA 4.0):https://creativecommons.org/licenses/by-nc-sa/4.0/deed.uk
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
