Using a flexible electric heating element as a heating device for biogas reactors
DOI:
https://doi.org/10.31548/energiya4(74).2024.065Abstract
The article is devoted to the issue of research on the influence of the mass-dimensional characteristics of the combined mixing and electric heating system on the amount of heat released during its cooling. The main hypothesis of the work is that due to the use of the amount of heat accumulated by the combined system of mixing and electric heating during operation, it will be possible to save energy for heating the substance in the reactors. Savings arise due to an increase in the duration between the cycles of turning on the heating device. The article presents the results of numerical studies at different temperatures of the electric heating element, reactor volumes, and mass-size characteristics of the combined system.
The dependence of the change in the amount released during cooling of the combined mixing and electric heating system on the mass and dimensional characteristics of the system, the volume of the biogas reactor and the temperature of the heating element was established.
The obtained results can be used in the design and construction of systems of mixing and electric heating of the substrate in biogas reactors and combined with an automatic control system. The established dependencies increase the profitability of biogas production and reduce the cost of 1 m3 of generated gas, due to the reduction of energy costs for maintaining the temperature and hydrodynamic conditions necessary for anaerobic fermentation to proceed.
Key words: energy, heating, mixing, flexible electric heater, biogas reactor, thermodynamic equilibrium
References
Ratushnyak, G. S., Dzhedzhula, V. V., Anokhin, K. V. (2010). Doslidzhennia parametriv protsesu peremishuvannia orhanichnoi masy v biohazovii ustanovtsi z vertykalnym propelernym peremishuvache [Energy-saving renewable heat sources]. Vinnitsa: VNTU, 170.
Pham C. H. Factors Affecting Process Temperature and Biogas Production in Small-scale Rural Biogas Digesters in Winter in Northern Vietnam / C. H. Pham, C. C. Vu, S. G. Sommer, S. Bruun // Asian Australas. J. Anim. Sci. - 2014. - V. 27 - № 7. - Р. 1050-1056.
Spodoba M. Zablodskiy M. Dependence of energy costs on the type of mechanical stirrer used in a biogas reactor. Electrical engineering and power engineering, 2021, (1), 26-33. https://doi.org/10.15588/1607-6761-2021-1-3
Zablodskiy M., Spodoba M., Spodoba O. (2022). Experimental study of energy losses of a biogas reactor to the environment in the mesophilic mode of fermentation. Energy and automation, 0(2), 18-32. http://dx.doi.org/10.31548/energiya2022.02.018
Zablodskiy M.M., Spodoba М.О. (2020). Improvement of the method for determining energy consumption in a biogas reactor. XII International Conference “Electronic Processes in Organic and Inorganic Materials” ICEPOM-12, (June 01-05, 2020), Kamianets-Podilskyi, 311.
D. Deublein and A. Steinhauser, "Biogas from Waste and Renewable Resources. An Introduction" in, Weinheim:KGaA, pp. 450, 2008.
Zablodskiy М., Spodoba M., Spodoba О. (2022). Experimental investigation of energy consumption for the process of initial heating of a substrate for the use of electric heat-mechanical system. Electrical Engineering and Power Engineering, (1), 49–59. https://doi.org/10.15588/1607-6761-2022-1-5
M. Spodoba and O. Spodoba, "Mathematical Model of Changes in Energy Costs for Thermostabilization of the Substrate and Objects in a Biogas Reactor," 2023 IEEE 5th International Conference on Modern Electrical and Energy System (MEES), Kremenchuk, Ukraine, 2023, pp. 1-6, https://doi.org/10.1109/MEES61502.2023.10402431
Downloads
Published
Issue
Section
License
Relationship between right holders and users shall be governed by the terms of the license Creative Commons Attribution – non-commercial – Distribution On Same Conditions 4.0 international (CC BY-NC-SA 4.0):https://creativecommons.org/licenses/by-nc-sa/4.0/deed.uk
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).