ОСОБЛИВОСТІ ДЕФОРМУВАННЯ ДЕРЕВИНИ З ВАДАМИ
Abstract
ON DEFORMATION FEATURES OF WOOD WITH DEFECTS
N. Buiskykh, S. Frishev, V. Nesvidomin
Abstract. Wood, as an ecological material, is increasingly gaining popularity. However, a decrease in the quality of wood. Applicability timber of low quality in building structures raised the question of the definition of certain indicators of strain. The results of research on determination of deformations of round wood with defects under the influence of step-by-step increasing loading are given in this article. The round wood for this research has been supplied from Kyiv region. There were studied ten control samples and samples of ten knots. Elastic deformations and deformation return after unloading were measured. Moisture of samples, diameter, average dimensions of the greatest knots were taken into account during testing. After testing the samples destroyed. The results of the study concluded that the process of deformation of wood with knots and without knots for actions in step-by-step of growing stress at compression along wood fibers of the upper limit load below the conventional boundaries of proportionality, virtually identical, and deformation of samples with knots had more numerical value and increased with an increase in the size of knots.
Keywords: Pine logs, knot, deformability, loading along fibers, deformations.References
Пінчевська О. О. Ефективність використання низькотоварних круглих лісоматеріалів з деревини сосни / О. О. Пінчевська, Н. В. Буйських, В. М. Головач. – К. : Центр учбової літератури, 2015. –159 с.
Пінчевська О. О. Концептуальні напрямки раціонального використання деревної сировини / О. О. Пінчевська, Н. В. Марченко, А. К. Спірочкін та ін. – К. : Центр учбової літератури, 2016. –315 с.
Куницкая О. А. Новые материалы из низкотоварной древесины и изделия из них / О. А. Куницкая, ?. В. Григорьев // Актуальные направления научных исследований XXI века: теория и практика : сборник научных трудов по материалам международной заочной научно-практической конференции. –Воронеж: ВГЛТА, 2014. – Т. 2. – С. 22–26.
Титунин А. А. Приоритетное направление ресурсосбережения в домостроении / А. А. Титунин // Достижения и проблемы материаловедения и модернизации строительной индустрии : vатериалы XV Академических чтений РААСН – Междунар. научн.-техн. конф. – Казань : КазГАСУ, 2010. – Т. 2. – С. 253–257.
Пятикрестовский К. П. Современные критерии прочности древесины и возможности программирования расчета комплексных конструкций при сложном напряженном состоянии / К. П. Пятикрестовский, Б. С. Соколов, В. ?. Травуш // Строительные науки. ‒ 2015. ‒ № 3. – С. 125‒131.
Buiskykh N. Features of parallel to graine deformation in pine structural round-wood under rate increasing loading / N. Buiskykh // Annals of Warsaw University of Life Sciences – SGGW Forestry and Wood Technology. – 2013. – № 81. – Р. 27–29.
Левченко В. П. Деформативность древесины сосны строительных размеров с сучками под действием повторной статической загрузки / В. П. Левченко // Лесоводство и лесоведение. – 1974. – С. 109–114.
?ванов Ю. М. Деформация древесины под действием повторной статической нагрузки при сжатии вдоль волокон / Ю. М. ?ванов // Сборник ЦНИ?ПС. Вопросы прочности и изготовления деревянных конструкций. – 1952. – С. 7–47.
Лехницкий С. Г. Теория упругости анизотропного тела / С. Г. Лехницкий. – М. : Наука, 1977. ‒ 415 с.
Пінчевська О. О. Деформування деревини під дією повторних статичних навантажень / О. О. Пінчевська, Н. В. Буйських // Науковий вісник Харківського національного технічного університету сільського господарства ім. Петра Василенка. – 2012. – Вип.123. – С. 34–38.
Downloads
Published
Issue
Section
License
Relationship between right holders and users shall be governed by the terms of the license Creative Commons Attribution – non-commercial – Distribution On Same Conditions 4.0 international (CC BY-NC-SA 4.0):https://creativecommons.org/licenses/by-nc-sa/4.0/deed.uk
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).