Experimental study of the characteristics of a vertical-axis wind turbine with a stationary confuser under varying active load resistance
DOI:
https://doi.org/10.31548/energiya4(86).2026.057Keywords:
vertical-axis wind turbine (VAWT), wind flow concentrator, electrical load, electromechanical complex, energy efficiency, wind tunnelAbstract
Experimental studies of a vertical-axis wind turbine have been conducted, demonstrating the effectiveness of using a wind flow concentrator to increase the power output of such turbines. It has been established that investigating the flow conditions around the wind generator in a wind tunnel with a concentrator allowed for a significant reduction in the rotor's cut-in speed. The impact of the concentrator on increasing the wind generator's power was studied, showing that the power value under steady wind flow conditions in the wind tunnel can increase up to 4 times. The importance of electromechanical matching of the "generator-load" system to realize the maximum energy potential of the wind installation is demonstrated. It has been determined that for the investigated "wind turbine - concentrator" complex, the optimal electrical circuit resistance is 100 Ohms, which ensures the optimal balance between the rotor's speed characteristics and power extraction. Decreasing the circuit resistance leads to excessive electromagnetic braking and a reduction in the rotor's rotational speed, while increasing the resistance causes the generator to operate in a mode close to an idle state, resulting in underutilization of its useful power. It is shown that using a three-phase Larionov bridge rectifier based on Schottky diodes reduces switching voltage losses to minimum values, which is a necessary condition for initiating electricity generation at the starting stages of the wind turbine rotor's rotation. The results of the experimental studies for various operating modes of the "wind turbine - wind flow concentrator" system demonstrate the prospects of using such a wind generator design for the further development of industrial prototypes of small and medium-capacity wind turbines.
Recieved: 15.06.2025. Recieved: 12.08.2026. Accepted: 20.08.2026
References
1. Omelchenko, V. (2023). Prospects for the development of wind energy in the conditions of decentralization of the energy system of Ukraine [Perspektyvy rozvytku vitroenerhetyky v umovakh detsentralizatsii enerhosystemy Ukrainy]. Vidnovluvana enerhetyka, (2), 15–22.
2. Kulyk, V., Pobilun, V., & Lyzhychko, B. (2019). Analysis of the efficiency of wind power plants in the Carpathian region [Analiz efektyvnosti vykorystannia vitroenerhetychnykh ustanovok v umovakh Karpatskoho rehionu]. Vidnovluvana enerhetyka, (2), 15–23.
3. Balduzzi, F., et al. (2020). The potential of building-integrated wind energy in urban environments. Renewable and Sustainable Energy Reviews, 130, 109956.
4. Pope, K., Dincer, I., & Naterer, G. F. (2010). Energy and exergy efficiency comparison of horizontal and vertical axis wind turbines. Renewable Energy, 35(9), 2102–2113. https://doi.org/10.1016/j.renene.2010.02.013
5. Eriksson, S., Bernhoff, H., & Leijon, M. (2008). Evaluation of different turbine concepts for wind power. Renewable and Sustainable Energy Reviews, 12(5), 1419–1434.
6. Altan, B. D., & Atilgan, M. (2008). An experimental and numerical study on the improvement of the performance of Savonius wind rotor. Energy Conversion and Management, 49(12), 3425–3432. https://doi.org/10.1016/j.enconman.2008.08.021
7. Alom, N., & Saha, U. K. (2021). Performance analysis of a Savonius wind turbine with a deflector system. Journal of Wind Engineering and Industrial Aerodynamics, 212, 104586.
8. Wong, R. C. W., et al. (2017). Performance enhancements on vertical axis wind turbines using flow augmentation systems: A review. Renewable and Sustainable Energy Reviews, 73, 904–921. https://doi.org/10.1016/j.rser.2017.01.160
9. Shchur, I. Z. (2018). Electromechanical systems of renewable energy [Elektromekhanichni systemy vidnovluvalnoi enerhetyky]. Lviv: Lviv Polytechnic Publishing House.
10. Boldea, I. (2006). Variable Speed Generators. Boca Raton: CRC Press.
11. Korprasertsak, N., & Leephakpreeda, T. (2019). Analysis and optimization of wind boosters for low-speed vertical axis wind turbines. Journal of Wind Engineering and Industrial Aerodynamics, 189, 150–162. https://doi.org/10.1016/j.jweia.2019.03.023
12. Sengupta, A. R., Biswas, A., & Gupta, R. (2021). Investigation of guide vane effects on the performance of a vertical axis wind turbine. Renewable Energy, 165, 132–145.
13. Gorobets, V., et al. (2021). CFD modeling of aerodynamic flow in a wind turbine with vertical rotational axis and wind flow concentrator. INMATEH - Agricultural Engineering, 64(2), 159–166.
14. Gorobets, V., et al. (2025). Parametric optimization of curvilinear confuser-type channel. Engineering for Rural Development, 24, 112–118.
15. Hassan, A., et al. (2021). A Review of MPPT Techniques for PMSG Based Wind Energy Conversion Systems. International Journal of Renewable Energy Research, 11(4), 1560–1570.
16. Zhao, Z., et al. (2022). Efficiency Optimization Control of PMSG-Based Wind Power Generation System. IEEE Access, 10, 34567–34578.
17. Hrebenikov, V. V., & Hamulia, M. Y. (2019). Electromechanical systems with permanent magnets: monograph [Elektromekhanichni systemy z postiinymy mahnitamy]. Kyiv: Institute of Electrodynamics of the NAS of Ukraine.
18. Torkaman, H., & Keyhani, A. (2020). Special Issue on Design and Control of PM Machines. IEEE Transactions on Energy Conversion, 35(1), 120–122.
Published
Issue
Section
License
Copyright (c) 2026 Energy and Automation
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
All materials are disseminated under the terms of the Creative Commons Attribution 4.0 International Public License, which permits others to distribute the manuscript with proper acknowledgement of the authorship and the original publication in this journal.
